This test determines the ignitability of PV modules by direct small flame impingement under zero impressed irradiance by external heat sources using vertically oriented test specimens. The test does n

The ammonia chamber applies ammonia gas to accelerate the corrosion of materials or products under certain temperature environment, so as to reproduce the damage degree of materials or products within

Undertake power station operation and maintenance services to protect the power generation of the power station.

The sand test chamber is driven by a high-power fan to blow a certain concentration of sand dust over the surface of the test samples at a certain flow rate, so as to evaluate the ability of these tes

PV Booster is used to improve the yiel and improve your profit.var player = polyvObject(#plv_9e882fa0c766a6c96df719b888c2579c_9).videoPlayer({width:480,height:300,vid : 9e882fa0c766a6c96df719b888c2579

ANTIPID is used to recover low power modules caused by PID in solar power plants and to prevent PID problems in power plants. Installed on the DC side of the inverter, and the voltage is applied to

This salt mist corrosion test chamber is suitable for accelerating salt mist corrosion test of industrial products such as electronic devices, product parts, protective layer of metal materials, etc.

Provide leasing service of PV mobile test platform, which can conduct IV test under STC condition, EL test, insulation test, grounding test, infrared thermal image test, inverter efficiency test, and

The solar cell mobile test platform is used for field test of solar power plants. It mainly performs STC power tests on modules, and also performs EL test, insulation test, earth test, infrared therma

Test the IV curve of solar module on the solar plant.

The device could cyclically scan the temperature of each channel.

Meet the Peel test strength test requirements in MST 35 & Lap shear strength test requirements in MST36 clause of the IEC61730-2:2016 standard. Also, the tester could be used in soldering peel t

Meet the accessibility test test requirement specified in MST11 clause of the IEC 61730-2:2016 standard.l Could test the ohm value;l Could check the press value;l The resistance value could b

Meet the Thermal cycling test(TC) requirements specified in the 4.11 clause of IEC 61215-2016 standard & MST51 clause of & IEC61730-2016 standard & 35 clause in UL1703 standard. Meet the H

Meet the Stability test requirements specified in 4.19(MQT19) clauses of IEC 61215:2016 standards. The system is designed for 10 pcs modules. Meet the Outdoor exposure test requirements specified in 4