Fully automatic hot spot cells selector meet the hot spot test requirements specified in 4.9 clause of the IEC 61215-2016 standard. l 3A light could be used to make the module generate cur

Meets the static mechanical test requirements in the 4.16(MQT16) clause of the IEC 61215-2016 standard. Also, meet the IEC TS 62872-2016 standard.l The cylinder drives the vacuum suction cup to pre

Meet the requirements for visual inspection of solar modules specified in 4.1(MQT01) clause of IEC 61215-2016 and MST01 in IEC 61730-2016.l This equipment is used for visual inspection of photovolt

Fire resistance requirements for a PV module intended for building applications are defined in local or national building codes. PV modules as building product – i.e. serving as roof covering materia

This test determines the ignitability of PV modules by direct small flame impingement under zero impressed irradiance by external heat sources using vertically oriented test specimens. The test does n

The ammonia chamber applies ammonia gas to accelerate the corrosion of materials or products under certain temperature environment, so as to reproduce the damage degree of materials or products within

The sand test chamber is driven by a high-power fan to blow a certain concentration of sand dust over the surface of the test samples at a certain flow rate, so as to evaluate the ability of these tes

This salt mist corrosion test chamber is suitable for accelerating salt mist corrosion test of industrial products such as electronic devices, product parts, protective layer of metal materials, etc.

Test the IV curve of solar module on the solar plant.

The device could cyclically scan the temperature of each channel.

Meet the Peel test strength test requirements in MST 35 & Lap shear strength test requirements in MST36 clause of the IEC61730-2:2016 standard. Also, the tester could be used in soldering peel t

Meet the accessibility test test requirement specified in MST11 clause of the IEC 61730-2:2016 standard.l Could test the ohm value;l Could check the press value;l The resistance value could b

Meet the Thermal cycling test(TC) requirements specified in the 4.11 clause of IEC 61215-2016 standard & MST51 clause of & IEC61730-2016 standard & 35 clause in UL1703 standard. Meet the H

Meet the Stability test requirements specified in 4.19(MQT19) clauses of IEC 61215:2016 standards. The system is designed for 10 pcs modules. Meet the Outdoor exposure test requirements specified in 4

This equipment is designed for testing the power and IV curve of solar module. The radiation class could meet 3A+ level specified in IEC60904-9 standards. It could be used to test silicon cell, thin f