The PV module push tester is to apply a certain force to a certain point on the surface of the module, so as to evaluate the performance of the module thrust resistance. Meets the Push test conditions

Meets the Terminal box knock out test requirements specified in the MST44 clause of the IEC 61730-2:2004 standard.l With special fixture for junction box；l Time relay could programmed to contro

This product is used to determine whether there is dangerous sharp edge of unreasonable injury on the edge of toys or articles. Meets the sharp edge test conditions in IEC 61730-2:2016、UL1439-2004、U

Meets the Conduit Bending test requirements specified in the MST33 clause of the IEC 61730-2:2004 standard.l The frequency of the controller could be set；l Pneumatic lifting support structure.

Meets the reverse current overload test requirements specified in the MST26 clause of the IEC61730 standard.l Can provide reverse current to the component.l Monitor the current.l Monitor the

Damp-Heat ChamberType: ZW-8000-DH * the system is in accordance with the IEC61215-2016 MQT13 & IEC61730-2016 MST53 test standards in solar energy industry(DH) var player = polyvObject(#plv_9e882fa

Humidity-Freeze ChamberType: ZW-5600-HF Meet the Damp heat(DH) requirement specified in 4.13 clause of IEC 61215-2016 standard & MST53 clause of & IEC61730-2016 standard. Meet the Thermal cycl

Meet the test requirements for the voltage withstanding and insulation resistance of solar modules specified in 4.3 clause of IEC 61215-2016 and MST16 in IEC 61730-2016. Meets the ground continuity te

Meet the temperature coefficient, NMOT (NOCT), outdoor exposure, hot spot test and power stability test requirements specified in 4.4, 4.5, 4.8, 4.9 and 4.19 clauses of IEC 61215:2016 standards. Meet

Meets the static mechanical test requirements in the 4.15 clause of the IEC 61215-2016 standard, 41 clause of UL1703 and MST34 clause of IEC61730-2016 standard.l Using sandbags as a gravity source

Meet the insulation test & wet leakage current test requirements specified in 4.3(MQT03), 4.15(MQT15) clause of IEC 61215-2016, MST16, MST17 clause of IEC61730.l Including insulation test table

Meets the robustness of terminals test requirements specified in 4.14(MQT14) clause of the IEC 61215-2016 standard.l Test for module as per MQT 14-1 clause in IEC61215.l Test cable and connector